Request a quote

ROTRIX system requirements for the RTS Compact 5, a 5 kgf thrust and torque stand. Partial answers are fine and can be refined later. Download the Word form

1. Organization

Organization name

Contact person

Phone

Installation location Expected timeline

2. Test objective Primary purpose Testing scope Daily testing volume Test profiles

Manual Automated sweep Endurance Custom profile

Duty cycles

Continuous run Stepped load Ramp Endurance cycle Transient testing

3. Motor and propeller Motor outer diameter

100–110 mm 140–165 mm 200 mm

Motor KV

100 KV 330 KV 1100 KV 1700 KV

Thrust range

5 kg, this stand 15 kg 20 kg 30 kg 50 kg

Torque range

6 Nm 9 Nm 15 Nm 30 Nm

RPM range

15,000 20,000 25,000 35,000

Power range

3 kW 5 kW 7 kW 10 kW

Propeller diameter

28 inch 30 inch 32 inch

4. Sensors

Current RPM Thrust Torque Temperature Vibration

Thermocouples required

5. Data communication

USB Ethernet UART / Serial

Approximate cable length

6. Real-time monitoring Live streaming into ROTRIX DAQ

YesNo

Historical benchmarking and multi-test comparison

YesNo

7. Logging and reporting

CSV XLSX PDF report

File structure or naming convention Timestamp format Units

MetricImperial

8. Performance curves

Thrust and efficiency vs RPM Thrust and efficiency vs torque Power and efficiency vs thrust Thermal trends Anomaly detection

Samples of data, plots, or reports

9. Existing thrust bed, if you have one Model, sensors, controller, sample rate, protocol, calibration, and output structure

10. Support

On-site Remote Both Not required

Training

YesNo

Anything else for the quote

This prepares your completed SRS so you can send it to REUDE Technologies.

Your specification is ready

A copy was saved to your device. Send that file to REUDE Technologies to receive a quote for the RTS Compact 5. You can also call +91 63846 67822.

Return to the 3D viewer